???? I could not test this, since it did not seem to work.
Task 103380
<< Yanhua Huang -- 08/24/07 14:30:21>>
Test work will be mainly focused on Constructed Features, alignment and scan.
Yanhua
<<END>>
<< Yanhua Huang -- 08/23/07 15:42:49>>
Rick,
Main code has been completed. More works about it will be focused on the PRs relative to IP translator.
Yanhua
<<END>>
<< Changes made by Yanhua Huang -- 08/23/07 15:43:10>>
Action: Yanhua Huang to Rick Tischler, Status: CODING to REVIEW
<<END>>
<< Yanhua Huang -- 08/17/07 13:33:17>>
Design document is updated. And design module (created by rose 2003) is uploaded.
Yanhua
<<END>>
<< Changes made by Yanhua Huang -- 08/13/07 22:10:01>>
Action: Rick Tischler to Yanhua Huang
<<END>>
<< Yanhua Huang -- 08/02/07 21:02:23>>
Alignment, distance, location and angle are supported.
Yanhua
<<END>>
<< Changes made by Yanhua Huang -- 07/18/07 20:32:49>>
Status: REVIEW to CODING
<<END>>
<< Yanhua Huang -- 07/16/07 18:41:05>>
Designed.
Yanhua
<<END>>
<< Changes made by Yanhua Huang -- 07/16/07 18:41:21>>
Action: Yanhua Huang to Rick Tischler, Status: DESIGN to REVIEW
<<END>>
<< Yanhua Huang -- 07/05/07 18:21:23>>
Rick said:
We need to be able to create an iPlan (IP command file) from an existing part program. So we need a method of having each auto feature, dimension, and alignment in the part program write their iPlan command to a file. We also need to run down the part program and output the entire iPlan to a file.
Yanhua
<<END>>