Feature Type: Select the feature type from the drop-down list.
ID: Provides the name for the feature that will be created based on the selected feature type.
XYZ: These values define the Point, Center, Start or End positions for the Auto Feature.
IJK: These values define the Surface, Edge, Normal and Angle Vectors for the Auto Feature.
The
Find Nearest CAD Element icon
tells Inspection Planner to find the nearest CAD element in the Graphics
Display window based on the XYZ location. Only available for Point (Surface,
Edge, Angle & Corner), Line and Plane features. If you select one
of the XYX axis buttons, only
that value will be adjusted to the nearest CAD element.
The
Find Vector icon will pierce all
surfaces along the XYZ point and IJK vector looking for the closest point.
The surface normal vector will be displayed as the IJK NOM VEC but the
XYZ values will not change. Only available for Surface Points.
The
Flip Vector icon allows you to
reverse the direction of the surface vectors. Click on Flip Vector to
reverse the displayed values.
Diameter: Diameter for a Circle, Polygon, Cylinder or Sphere feature.
Major Diam: Diameter for the length of an Ellipse feature.
Minor Diam: Diameter for the width of an Ellipse feature.
Width: Width for a Square, Round or Notch Slot feature.
Length: Length for a Square, Round or Notch Slot feature. This also defines the length for a Cylinder or Cone feature.
Gap: Defines the distance of the Gap between the two sides of a Flush and Gap feature.
Num Sides: Determines the number of sides of a Polygon feature.
Diameter 1: Specifies the diameter for a Cone feature at the XYZ location of the cone.
Diameter 2: Specifies the diameter for a Cone feature at the end of the length of the cone.
Angle: The apex angle of a cone feature.