Getting Started: Multi Gage Tutorial

If you are new to using Multi Gage, this is a good place to start in order to gain a general knowledge of the Multi Gage product.

Follows these steps to become familiar with Multi Gage:

• Step 1: Set Up Your Multi Gage Arm

• Step 2: Attach the Multi Gage Arm to the Computer

• Step 3: Install PC-DMIS Multi Gage

• Step 4: Launch PC-DMIS Multi Gage

• Step 5: Calibrate Your Probe

• Step 6: Measure a Few Features

• Step 7: Construct Features from Measured Features

• Step 8: Dimension the Measured Features

• Step 9: Review the Report

• Step 10: Print a Report